Yes gjstroom, I've already saw that August the 22 drivers, the question is I am still not able to download the .sh script (
[DOWNLOAD] How to update drivers & apply driver protection) in order to apply that (I still have to wait 24 hours after my 5th message in this forum). I have a Sunray Solo2 and I would like to install the last Openspa image's version which is 7.1.003.
I've been reading the posts of this forum and first of all I would like to thank you all your efforts and support.
As I've understand I would have to flash the original image in the clone receiver (not in the original one) and this receiver has to be disconnected from the dish and without Internet connection. It has to be connected to a computer with an ethernet wire only and this computer has to be disconnected from the Internet in order to avoid the update which could cause the "bomb" to corrupt the NAND memory of the receiver.
I've been reading this manual procedure too:
New patched Sunray Solo2 drivers 20170522
I have some questions mainly.
1) The first one is that Openspa uses a wizard for the first time you use it after install or flash the image. In this wizard there are some steps to connect the receiver to the Internet and do some updates (for plugins and other useful and necessary things). When do I have to telnet the new August the 22 patched drivers to "lib/modules/3.13.5/extra/" folder?
2) What is the right command to apply from telnet to extract the drivers to "lib/modules/3.13.5/extra/" folder? (I make this question because there are a lot of commands on that page and it would be confusing to me, thanks).
Which are the right drivers?: a) vuplus-dvb-modules-vusolo2-3.13.5-20170822.tar.gz or b) vuplus-dvb-proxy-vusolo2-3.13.5-20170822.r0.tar.gz (taken from
STACK)
I've read that one of them are applied to images that have Kodi (like Openspa I think).
3) After applying these drivers when can I plug all the wires from the dish and Internet connection to the receiver again? Have I to restart the receiver?
4) Could I do all this patching procedure on an original Solo2 receiver, make a backup of it and then flash that backup on the Sunray clone?
Excuse me for all these questions, I've been reading this subforum but there are some aspects I still haven't understood perfectly and it could be dangerous for bricking the Sunray Solo2 receiver. I would like to do this procedures manually with commands if were possible (for more knowledge) and after it using the .sh script too.
There was two years after I updated my Sunray Solo2 receiver using a patched image made by ramiMAHER from Dreamoem forum but now that project seems to be closed...So now I would like to restart patching the lastest images by myself instead of downloading the images already patched by others.
Thank you all for reading these huge "letter" I've made some minutes ago and excuse me for my bad English, I'm from Spain and I try to improve it everyday, trust me...