need help with atmel reading

[chad]

i have tock the atmels out a pace 2000di to get box key but the thing is
i read them with a wilem 4.5 all went ok then i used b.k 2 to get box key and it give me most the number but i notice that 2 number in the idr or wrong so tryed aging still the same eny 1 help me out hear please been on it all day thanks all

 

[roasted3]

mate get a metal ruler or flat surface and use either a stanley knife the long thin type . and put the atmel on ruler or flat surface and push the stanley knife across the atmel legs be very careful and push down on them all at the sametime. ... this will make the atmel nice and level ..... do the same for both atmels. and then reread them with your willem. that should do the trix. rember to be careful.

 

[Satch]

i have tock the atmels out a pace 2000di to get box key but the thing is
i read them with a wilem 4.5 all went ok then i used b.k 2 to get box key and it give me most the number but i notice that 2 number in the idr or wrong so tryed aging still the same eny 1 help me out hear please been on it all day thanks all

HiYa,

Just wondered what setting you use Chad?

 

[chad]

the seting are 3 on the frist dip 2 3 5 6 8 10 12 on thats on the second dip
jumper on vpp and 29f in the eprom3 that i used the chip was set to read
at49lv1614 with just skip write ticked and ive cleaned all legs and still get the same

 

[Satch]

the seting are 3 on the frist dip 2 3 5 6 8 10 12 on thats on the second dip
jumper on vpp and 29f in the eprom3 that i used the chip was set to read
at49lv1614 with just skip write ticked and ive cleaned all legs and still get the same

HiYa,

Here's a couple of screen shots I did a while ago when I managed my first reading when I was playing.

 

[bammy]

use 29lv160, make sure you id the chip correctly before reading.

 

[chad]

thanks lads your all good lads box sorted setting wrong it was this at49lv1614
should of been 29lv160, so thanks all