Meelo + SE: After boot logo, bootloop..rebooting

[GRACCO]

hi,
i have a new meelo+SE and after i make configured it and reboot it; my receiver after power on see bootlogo but rebooting always.
i try to update firmware with usb and all works, then i can see new bootlogo but then it rebooting always.
as can i relsove thi problem?

 

[Ferret]

If you have reflashed and it still goes into boot loop its not a software issue or doubtful. Make sure all usb devices have been removed.

Try another PSU as a failing PSU could produce those symptoms

 

[GRACCO]

all usb are removed...then could be the power supply??

 

[Ferret]

Could be you need to try another.

 

[GRACCO]

my psu is 12 v 3.5 A, i have traied with 12v 3 A but always the same.
i finding a 12 v 3.5 A now...

 

[GRACCO]

i update with safety firmware Meelo+SE but it boot and after bootlogo i have black screen and after few minutes reboot. ☹

 

[GRACCO]

i used any psu but rebooting.... Can you help me??

 

[GRACCO]

is it possible update meelo+SE with RS 232? And as and what firmware/software??

 

[Ferret]

Not sure what the problem is mate but if your booting as far as a bootlogo the bootloader is ok.

You can not flash an image via rs232 only by usb.

Sunray solo2 image are compatible with you melo.

 

[GRACCO]

h have hade this problem after to have put in channell list, then i turn of and on my receiver and then bootloop.

 

[GRACCO]

i do not understand why by usb update firmware correctly but it goes Always into bootloop?

infact bootlogo changes after update

 

[Ferret]

Bootloop can be a sign of hardware failure. But before condemning it flash a sunray image to it.

 

[GRACCO]

i have just flashed many img even sunray but it is the same

 

[GRACCO]

and why when i turn it first time all it was ok? While after reboot no?

 

[GRACCO]

if it was a hardware problem it wasn't works just before