• This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn more.

How to reset pin pace Di 4000 T

dont do it it"ll hurt

VIP Member
VIP Member
Joined
Nov 16, 2006
Messages
8,231
Likes
163
#2
you need to reset the box m8 pull jumper or short battery
when you do this you have to reset id and pin
have a read a tut will tell you how to
 
Joined
Feb 1, 2007
Messages
119
Likes
1
#3
This should help you out mate



1000/2000 Series:
You can pull the red jumper but you'll still need libby to set your area or you can use Libby to do the whole works. Erasing SRAM is more advisable to do then pulling the RED JUMPER. Before using Libby, make sure you have got your box’s configuration file. (Check cable downloads section) and make sure you can connect (talk) your box with libby.

1. Boot into engineer menu (holding down the up and down arrow buttons).
2. Take note of you NET ID/area frequency on page one.
3. Run lib erase (clear) S-RAM using Libby. Your PIN number and area code will be erased (reset).
4. Set the NET ID using Libby.
5. Boot box in engineering menu and set your PIN and area frequency code.


4000 Series:
You can reset your PIN on a 4000N box without using Libby and opening your box
1. Assuming you've forgotten the PIN you put any old PIN in 5 times so that the box reports that the PIN is locked.
2. Go to the Menu option where you would unlock the PIN, and put in any old PIN (it shall probably tell you invalid pin entered).
3. Then reboot the box and go into Engineers menu (holding down the up and down arrow buttons whilst the box is being booted up).
4. You should now find that you can actually move down to the PIN option on the 1st page and reset the PIN using the buttons of the box.


4001 / 4010 Series:
You can reset your PIN on a 4001/4010 box without using Libby but shall need to open your box
1. Boot into engineer menu (holding down the up and down arrow buttons).
2. Take note of you NET ID/area frequency on page one.
3. Turn off box and remove the back of the box.
4. Look on the board and you will see a jumper (normally red), remove it and replace it after 2 minutes.
5. Reboot box back into engineers menu and change your frequency back (as noted in point 2).
6. Go to page 4, I think, where you can now change pin with the up arrow button. Remember the PIN you have chosen.
7. Reboot box and when you order a PPV, just type in your new pin.



NOTE: For the 2000 series, the following was suggested too. I have not tried it, but see you can try to see if it work's for you.


By Khan888

: multi : : multi : : multi : : multi :
 

eggie

Inactive User
Joined
Aug 23, 2005
Messages
289
Likes
0
#5
hi all

thanks evryone for ur replies, gladly appreciated it

Thanks
Eggie