Is it dead? My DI4001N has taken poorly the symptoms are:
Displays Pace => Tune => NiT => Pat fairly quickly.
Then it runs through a range of digits on the display for about 5 mins after which Pdld then ERRS is visible in the display for a few seconds, after this the display flashes all the characters and LED’s for about 2-3 mins then after that nothing it just sits there with the middle LED lit.
Its for all the world as though it is going through its update routine but never finishing.
If left in stream it goes through the above routine all by itself every 5 mins or so.
Nothing on screen at all during or after the above process (did have updating message see below).
Can’t access engs menu.
No amount of pressing different button combinations has produced anything other than the above.
Pulling the red jumper did make the “updating your service” message disappear permanently though.
Subbed box on same stream works a peach (DI4001NC).
Second box DI4010N works fine too.
I had a look at TWOBEERCANS 4001 repair guide and the box is showing a healthy 35.8 tuning volts, before I pull the motherboard and whip off the smd caps is there anything I am missing (aside from my telly Lol).
any and all help appreciated.
Displays Pace => Tune => NiT => Pat fairly quickly.
Then it runs through a range of digits on the display for about 5 mins after which Pdld then ERRS is visible in the display for a few seconds, after this the display flashes all the characters and LED’s for about 2-3 mins then after that nothing it just sits there with the middle LED lit.
Its for all the world as though it is going through its update routine but never finishing.
If left in stream it goes through the above routine all by itself every 5 mins or so.
Nothing on screen at all during or after the above process (did have updating message see below).
Can’t access engs menu.
No amount of pressing different button combinations has produced anything other than the above.
Pulling the red jumper did make the “updating your service” message disappear permanently though.
Subbed box on same stream works a peach (DI4001NC).
Second box DI4010N works fine too.
I had a look at TWOBEERCANS 4001 repair guide and the box is showing a healthy 35.8 tuning volts, before I pull the motherboard and whip off the smd caps is there anything I am missing (aside from my telly Lol).
any and all help appreciated.