Quick guide from start to finish on Sammy
You need to short the battery for 10 seconds, with a bit of wire.
Then put it in stream and let it update.
Then remove the 2 talkback resistors if it hasn't been done.
Then you can JTAG.
Get BKE2.2 up and running.Check the config1.ini numbers are correct ( 00f6a8a8) for pure ntl.
Power on the box, when the display shows LD20, press and hold ch down until the display shows LD40 . Wait a few seconds then let go of ch down button.
Wait till the on/off button led changes from red to green. Now the box is in debug mode. You don't have to wait for the display to show '0'
Align the JTAG pins to the left( towards the front of the box) with the side that has just 2 pins to the edge of the case. Push the pcb up and down a few times and then click 'connect' on BKE.........