Can Somebody Please Help on SAGEM

[black_arab]

I have just received a Sagem 1X and I have the following messages.

On the LCD screen I have PREMIERE Einen Moment Bitte which stays for a long time.

Now it says Ihr receiver hat den. Fehlercode UD4. Mit "ok" starten sie neu, andere Tasten bringen Sie weiter.

When I press OK the box just re-boots exactly the same way

I have done many of these with no problems, I have tried both FTP and IFA which have been successful in the past.

Any help would be much appreciated.

many thanks in advance
black_arab

 

[derekwd]

Dont think its in de-bug mode m8

 

[black_arab]

Dont think its in de-bug mode m8

That is exactly what I thought m8. Is that easy to do or should I just send it back. The fleebay ad said it was in debug and had the latest Linux and Sportster image on.

 

[derekwd]

Never done it myself but by all accounts it is very easy to do, i am sure there are plenty of ppl on here that can help should you get stuck.
good luck

 

[mgb]

If you get such a screen on boot up for a few seconds debug mode is enabled.

 

[black_arab]

So Far So Good

If you get such a screen on boot up for a few seconds debug mode is enabled.

Right I have managed to get the box to the screen you show. Now do I need to put Neutrino on. Because after putting into debug mode and re-booting it comes back to PREMIERE Einen Moment Bitte

 

[Speedy2206]

You now need to use IFA (Image Flashing Assistant) to flash a new image onto the box. I recommend a Sportster or gav's new updated image.

Then you're done!

 

[black_arab]

You now need to use IFA (Image Flashing Assistant) to flash a new image onto the box. I recommend a Sportster or gav's new updated image.

Then you're done!

Sorry Liam for sounding a little dumb as this is my very first effort to debug. I am left with the screen as above. Where does Neutrino come into it?

Thanks for you replies

 

[Speedy2206]

Sportster or any of the other images in the downloads section are 'Neutrino-based' images - thats where the neutrino comes in to it.

You can also get 'enigma' images, but you should stick with a neutrino image for now.

Liam.

 

[Fergalsworld]

Just do as liam says and use ifa to flash a new image on to it
make sure you use a 1x image this will sort everthing out for you.
Hope this helps.

 

[black_arab]

Thanks guys for all your help. I think I must have a problem with IFA. I have used it several times before with no problems but lately I havent been able to flash using it so I have FTP'd instead. Its obviously a problem with my equipment and I'm sure I will sort it.

Strangely it started to go wrong when I added a second network card to use specifically with my Dbox. I have since removed the card and its only IFA that I get problems.

Thanks again black_arab

 

[zaphoddigital]

Sometimes you have to reset the box a few times in order for IFA to hook onto it properly and for the box to display flashing. Persistance will usually pay here

 

[loady]

Yeah, make sure ALL your firewalls are OFF when you do it, when so mine goes first time.