1000 Series:
You can pull the red jumper but you'll still need libby to set your area or you can use Libby to do the whole works. Before using Libby, make sure you have got your box’s configuration file. (Check cable downloads section) and make sure you can connect (talk) your box with libby.
1. Boot into engineer menu (holding down the up and down arrow buttons).
2. Take note of you NET ID/area frequency on page one.
3. Run lib erase (clear) S-RAM using Libby. Your PIN number and area code will be erased (reset).
4. Set the NET ID using Libby.
5. Boot box in engineering menu and set your PIN and area frequency code.