ambit 200

chef1

Inactive User
Joined
Sep 12, 2007
Messages
86
Reaction score
29
I flashed an ambit 200 lastnight with sigmax2_125_cracked_dump.bin all went well
when i coonect the modem to the coax it scans for freq. so i put in the stop command.
I put in a working mac, freq and cofig but the modem wont come online
Am i msiing something or is there a better firmware for the 200. Also i flashed a 255 no problem and can get it working with the same mac and config

thanks for any help Paul
 
Hi Paul, your FW should be fine i use the Sigma x2 13.5 fercsa FW on my 200 my self, as for your not locking on problem it sounds like it could be your Annex is set wrong m8.

All u need to do is this below in hyperterminal as the ambit tool wont setup the correct annex mode.

cd /cm_hal
scan_stop

then press enter

and then this command below if ur in pure ntl or tw

cd /non-vol/halif
cm_tuner 14
annex_a
cm_annex 3

then press enter & type write & press enter

power cycle the modem and it should lock on & go online.

now if ur in tw area and that the above didnt work, then try this command below

cd /non-vol/halif
cm_tuner 14
annex_a
cm_annex 0

If you still get problems when bpi is enable u will need to go http://192.168.100.1:1337 and make sure embedded telnet server is enable then then run hyperterminal and use the commands below to disable it.

cd /cm_hal
scan_stop

press enter then copy and paste this into hyperterminal

cd /non-vol/docsis
enable bpi false
write

Hope that helps you get online m8, Good luck. ;)
 
Hi Paul, your FW should be fine i use the Sigma x2 13.5 fercsa FW on my 200 my self, as for your not locking on problem it sounds like it could be your Annex is set wrong m8.

All u need to do is this below in hyperterminal as the ambit tool wont setup the correct annex mode.

cd /cm_hal
scan_stop

then press enter

and then this command below if ur in pure ntl or tw

cd /non-vol/halif
cm_tuner 14
annex_a
cm_annex 3

then press enter & type write & press enter



power cycle the modem and it should lock on & go online.

now if ur in tw area and that the above didnt work, then try this command below

cd /non-vol/halif
cm_tuner 14
annex_a
cm_annex 0

If you still get problems when bpi is enable u will need to go http://192.168.100.1:1337 and make sure embedded telnet server is enable then then run hyperterminal and use the commands below to disable it.

cd /cm_hal
scan_stop

press enter then copy and paste this into hyperterminal

cd /non-vol/docsis
enable bpi false
write

Hope that helps you get online m8, Good luck. ;)




thanks m8 will let u know how i get on

Thanks Paul
 
Back
Top