ambit 120

fallenhalo

Inactive User
Joined
Jun 12, 2005
Messages
369
Reaction score
1
can some one please tell me if there is a "no update mod" for a 120 i have done a few 200 and worked fine but wasnt sure if there was one for a 120 any help would be appriciated thanks
 
yes....but its not recommended unless you solder for a living

you need to solder a link from pin 11 on the tsop and take this to 3.3v,requires a very skilled hand
 
ah right so no update mod that can be done same way as the 200 ? thanks for ya help anyway
 
You could always put a razor blade either side of pin 11 to stop any solder from touching pin 10 or pin 12
 
PLEASE COULD SOMEONE TELL ME WERE THE pin 11 IS on the tsop, (WERE IS THE tsop) and IS THE 3.3v, CONNECTION WERE I CONNECTED THE MAX on the modem.
 
Pin eleven

Its the side of the the chip nearest to where you plugged the max 233 in.
Count down untill you get to eleven.
I managed to solder it by luck rather than skill.
I like the razor blade idea.
I was thinking soldering a solid wire like a fuse wire to it.
Then normal wire to that.
Is there anywhere under the board that can be soldered to,that anyone has found.
Would it matter if the wire touch pin 10,cos i read it does,nt actually do anything.
 
Back
Top