250 problem

[not2bad]

have just tried flashing a ambit 250. All was going fine until i had to store the new firmware. I pressed the wrong button and now when i try and access it via hyperterminal nothing. The last line did say CRASH ! Is it time to bin this one or is there someway of flashing it back ?

It also wont give out an i.p if i try set i.p settings to auto allocate.

I have done one before so i know i'm doing it right just pressed the wrong button to store.

 

[gentlex]

have just tried flashing a ambit 250. All was going fine until i had to store the new firmware. I pressed the wrong button and now when i try and access it via hyperterminal nothing. The last line did say CRASH ! Is it time to bin this one or is there someway of flashing it back ?

It also wont give out an i.p if i try set i.p settings to auto allocate.

I have done one before so i know i'm doing it right just pressed the wrong button to store.

flash it again

 

[not2bad]

thats the problem it wont let me access it to flash it. It doesnt display any text once i connected it and turn it on.

 

[not2bad]

shall i just throw it away ?

 

[gentlex]

thats the problem it wont let me access it to flash it. It doesnt display any text once i connected it and turn it on.

do u get any text in hyper

 

[papa2]

If you have connected it up correctly and cant flash ,am afraid you'll just have to
bin it, these cant be recovered yet ,I've got the one the same problem,

you can flash a new bootloader on a 200 but not a 250

 

[not2bad]

@ gentlex - nope no text at all once rs232 connected.

@ papa2 - thanks i thought as much ah well, it might make a good bookend.

Thanks people !