250 problem

not2bad

Inactive User
Joined
Oct 16, 2006
Messages
228
Reaction score
1
have just tried flashing a ambit 250. All was going fine until i had to store the new firmware. I pressed the wrong button and now when i try and access it via hyperterminal nothing. The last line did say CRASH ! Is it time to bin this one or is there someway of flashing it back ?

It also wont give out an i.p if i try set i.p settings to auto allocate.

I have done one before so i know i'm doing it right just pressed the wrong button to store.
 

gentlex

Inactive User
Joined
Nov 4, 2005
Messages
4,775
Reaction score
62
have just tried flashing a ambit 250. All was going fine until i had to store the new firmware. I pressed the wrong button and now when i try and access it via hyperterminal nothing. The last line did say CRASH ! Is it time to bin this one or is there someway of flashing it back ?

It also wont give out an i.p if i try set i.p settings to auto allocate.

I have done one before so i know i'm doing it right just pressed the wrong button to store.

flash it again
 

not2bad

Inactive User
Joined
Oct 16, 2006
Messages
228
Reaction score
1
thats the problem it wont let me access it to flash it. It doesnt display any text once i connected it and turn it on.
 
Last edited:

papa2

DW Member +
Joined
Mar 15, 2006
Messages
782
Reaction score
80
If you have connected it up correctly and cant flash ,am afraid you'll just have to
bin it, these cant be recovered yet ,I've got the one the same problem,

you can flash a new bootloader on a 200 but not a 250
 

not2bad

Inactive User
Joined
Oct 16, 2006
Messages
228
Reaction score
1
@ gentlex - nope no text at all once rs232 connected.

@ papa2 - thanks i thought as much ah well, it might make a good bookend.

Thanks people !
 
TEST
Top