Guys trying to program my ambit 120 but keep getting this message
Detect ST M29W160DB Flash
Running image2 !!!!!
BCM3345 Image
S12ce7865 ##ECS Magic number was wrong. Working with default value.
Detect ST M29W160DB Flash
Updating parameter storage. This may take a while...
Location of Root is 80105ae0
Running from RAM
Detect ST M29W160DB Flash
This is image2
Detect a filesystem
Boot loader updated....
DNS service enable
DHCP Server init (Use Default)
4 Upstream Queues Configured.
Creating USB task
Flushing event log
Issue software reset
Waiting for reset finished
Init EMAC registers
USBD started
SenUSB NDIS Driver
Reading programmed USB Configuration...
dUSB init OK
encryptionInit Mibs
key requests
Use DHCP
VoIP card interface is NOT enabled.
The tuner is a TEMIC_4907_8768
The upstream amplifier is a MicroTune 1530
Periodic ranging timeouts are enabled
Preamble type will be set by the bur
Use default MCNS symbol rates.
Can't define a signal
Do i need to flash it? If so than what software do i use
Thanks in advance
Detect ST M29W160DB Flash
Running image2 !!!!!
BCM3345 Image
S12ce7865 ##ECS Magic number was wrong. Working with default value.
Detect ST M29W160DB Flash
Updating parameter storage. This may take a while...
Location of Root is 80105ae0
Running from RAM
Detect ST M29W160DB Flash
This is image2
Detect a filesystem
Boot loader updated....
DNS service enable
DHCP Server init (Use Default)
4 Upstream Queues Configured.
Creating USB task
Flushing event log
Issue software reset
Waiting for reset finished
Init EMAC registers
USBD started
SenUSB NDIS Driver
Reading programmed USB Configuration...
dUSB init OK
encryptionInit Mibs
key requests
Use DHCP
VoIP card interface is NOT enabled.
The tuner is a TEMIC_4907_8768
The upstream amplifier is a MicroTune 1530
Periodic ranging timeouts are enabled
Preamble type will be set by the bur
Use default MCNS symbol rates.
Can't define a signal
Do i need to flash it? If so than what software do i use
Thanks in advance
