Search results for query: *

I need some advise. I have been running a 5100i on a 10MB config for quite a while, it has just stopped working because it is trying to upgrade? My question is, if I install sigma on the modem and use a working MAC, what config will work. What will stop the modem from trying to update and...

I have a led simm with a single push button does anyone know what mods need doing? Many thanks

Thankyou very much!

Can anyone please tell me the dafault ip address on the above image. I don't have a remote with me! Thanks

I will try the first 'sticky' before asking any advice!

Can you update just the evocam in the nextgen image? I only ask as in lincoln it is a superbly stable image.

I know of 5 sagem 1x with nextgen all gone off in purentl any more??????

Why not just extend the earth plain if these 'shorts' are supposed to be there!

I am using a pcmcia to rs232 adaptor which is as good as a true com port. The dip switches were correct. I have returned the unit to unapit and we see what results the replacement produces. I really can't believe that the two points shorting those 2 tracks to earth are correct. I will...

All sorted. Couldn't get OCD to prduce it for some strange reason but SDT found it with the bytes from the post above. Thanks.

As stated I am asking for help in the bytes to jtag. Never had a problem with software 3.2 but nows it 3.3 cannot find it!

Can anyone please advise which bytes are required to find the BK. I'm pure nthell. I've tried the usual ones. Thanks

All I get is !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! Please help.

Heres a pic please confirm.

I am having serious problem communicating with the t911 nexus. I dont seem to be getting a Rx. Looking under the board I can see tracks 4 and 5 from the top (with the dip switches facing down) connected to the earth plain, this in the middle of the run from left to right, it looks like a...

A friends wants a box so I am trying to figure out my options on what I can do and what I can test. It sounds Like whatever I do cannot be tested. The only box from an NTL area is a sammy. If I purchase a TW box then I have no Libby. And best of all a sammy has been tried already but I...

I am pure ntl VOD but still running cr3_2. When did this cr4 come out?

Can I use a sammy? If so I presume I need to rewrite the ROM10 with the TW image then JTAG the box with the new net ID, the frequency should set itself? Finally without searching what do you use to set the net ID on a 4000 and 2000? Thanks

I have set the net id on a 4010 to 40984 which is a TW area. When I go into the engineers menu it shows as *****. The box has already upgraded to ntl cr3_2 What causes this, will it be ok when joins the stream?

I am moving from lincoln to North Lanarkshire and have a sammy. Will I have any problems? Do I need to set the net ID with JTAG to 40984 or will it update the net ID and frequency automatically? Many thanks.