Two dishes and two recievers

Hi everyone hope you can help a relative newbie. I have recently purchased a Technomate 6900 HD super which is in my main room. my 9100 super is now in conservatory, what I would like to do is to connect both of these to a motorised and a fixed dish. I understand I can place a disec switch after the moror for one receiver but to connect the second would a two to one connector before motor lose too much signal any help much appreciated.

you have to make only 1 reciver as the motor tunner as you can mess up the motor if you have the 2 recivers on the motor so choose witch one good luck

OK I can understand that, is it possible then to have my receiver in the conservatory(TM9100) set to just pick channels and not move the movable dish if so could you give me a quick heads up on what the settings should be. Again thanks for your quick responce.

private4587 said:

OK I can understand that, is it possible then to have my receiver in the conservatory(TM9100) set to just pick channels and not move the movable dish if so could you give me a quick heads up on what the settings should be. Again thanks for your quick responce.

Click to expand...

i dont have the the tm9100 / you need a twin lnb run sat wire to both reciver useing both conection 1/1 then set the reciver 6900 with the motor then conect the 9100 and go to menu and disable motor then if you have a secound dish set that up you will need a diseq switch get a x4 . now this get a little tricky as like i said no tm9100 ,i have a humax and echostar runing this way and when you connect the humax with diseq it auto take motor off and echostar very easy to set up . when you have the both recivers connected post again and give me 2-3 days and i speak to a friend for more info good luck

Thanks Lexmark for quick reply I am at work abroad at the moment so will have to wait until I get home to try.