bios password

kook

VIP Member
VIP Member
Joined
Feb 12, 2002
Messages
685
Reaction score
29
Location
london
does ne 1 no how to get the bios password for a packard bell pc

thanks kook
 
have you tried taking tyhe bios battery of the board and leave it out for a min then put it back that should set bios to default.
 
or just 'short' the two bios reset pins which should be next to the battery. Make sure system is UNPLUGGED then just connect the two pins with a screwdriver for a second
 
had the battery out for 30 hours it still keeps the password also tried the jumper short to no avail, its doing me head in think i will hammer it lol
 
Q13. I lost my password, what do I do now?

A13. There is no "backdoor" password unless the computer manufacturer modified the BIOS to have one. This is not typical in PhoenixBIOS. The password is stored in CMOS. Take these steps:

Clear the CMOS (remove the CMOS battery until POST displays a "CMOS checksum bad" message)
Re-install the CMOS battery
Run the BIOS Setup program
Load default values by pressing F9 and set whatever configuration is needed.
NOTE: It can take several days for the CMOS to go bad without a battery. This is caused by capacitance in the circuit. This charge can be safely discharged by using a 10k-ohm resistor, touched to the battery connectors for a few moments (while the battery is removed). If this procedure does not work, the system manufacturer may have a procedure that does work.

For more info..check this website..Might have some useful information:

http://www.geocities.com/SiliconValley/Pines/9725/phoenix.htm#Q12
 
KhuramG said:
Q13. I lost my password, what do I do now?

A13. There is no "backdoor" password unless the computer manufacturer modified the BIOS to have one. This is not typical in PhoenixBIOS. The password is stored in CMOS. Take these steps:

Clear the CMOS (remove the CMOS battery until POST displays a "CMOS checksum bad" message)
Re-install the CMOS battery
Run the BIOS Setup program
Load default values by pressing F9 and set whatever configuration is needed.
NOTE: It can take several days for the CMOS to go bad without a battery. This is caused by capacitance in the circuit. This charge can be safely discharged by using a 10k-ohm resistor, touched to the battery connectors for a few moments (while the battery is removed). If this procedure does not work, the system manufacturer may have a procedure that does work.

For more info..check this website..Might have some useful information:

http://www.geocities.com/SiliconValley/Pines/9725/phoenix.htm#Q12
does it matter what wattage the resistor is m8
 
DISCLAIMER



This article is intended for IT Professionals and systems administrators with experience servicing computer hardware. It is not intended for home users, hackers, or computer thieves attempting to crack the password on a stolen PC. Please do not attempt any of these procedures if you are unfamiliar with computer hardware, and please use this information responsibly. LabMice.net is not responsible for the use or misuse of this material, including loss of data, damage to hardware, or personal injury.





Before attempting to bypass the BIOS password on a computer, please take a minute to contact the hardware manufacturer support staff directly and ask for their recommended methods of bypassing the BIOS security. In the event the manufacturer cannot (or will not) help you, there are a number of methods that can be used to bypass or reset the BIOS password yourself. They include:

Using a manufacturers backdoor password to access the BIOS

Use password cracking software

Reset the CMOS using the jumpers or solder beads.

Removing the CMOS battery for at least 10 minutes

Overloading the keyboard buffer

Using a professional service

Please remember that most BIOS passwords do not protect the hard drive, so if you need to recover the data, simply remove the hard drive and install it in an identical system, or configure it as a slave drive in an existing system. The exception to this are laptops, especially IBM Thinkpads, which silently lock the hard drive if the supervisor password is enabled. If the supervisor password is reset without resetting the and hard drive as well, you will be unable to access the data on the drive.


--------------------------------------------------------------------------------

Backdoor passwords

Many BIOS manufacturers have provided backdoor passwords that can be used to access the BIOS setup in the event you have lost your password. These passwords are case sensitive, so you may wish to try a variety of combinations. Keep in mind that the key associated to "_" in the US keyboard corresponds to "?" in some European keyboards. Laptops typically have better BIOS security than desktop systems, and we are not aware of any backdoor passwords that will work with name brand laptops.

WARNING: Some BIOS configurations will lock you out of the system completely if you type in an incorrect password more than 3 times. Read your manufacturers documentation for the BIOS setting before you begin typing in passwords




Award BIOS backdoor passwords:

ALFAROME
ALLy
aLLy
aLLY
ALLY
aPAf
_award
AWARD_SW
AWARD?SW
AWARD SW
AWARD PW
AWKWARD
awkward BIOSTAR
CONCAT
CONDO
Condo
d8on
djonet
HLT
J64
J256
J262
j332
j322 KDD
Lkwpeter
LKWPETER
PINT
pint
SER
SKY_FOX
SYXZ
syxz
shift + syxz
TTPTHA
ZAAADA
ZBAAACA
ZJAAADC
01322222
589589
589721
595595
598598

AMI BIOS backdoor passwords:

AMI
AAAMMMIII
BIOS
PASSWORD
HEWITT RAND
AMI?SW
AMI_SW
LKWPETER
A.M.I.
CONDO

PHOENIX BIOS backdoor passwords:

phoenix, PHOENIX, CMOS, BIOS

MISC. COMMON PASSWORDS

ALFAROME
BIOSTAR
biostar
biosstar
CMOS
cmos LKWPETER
lkwpeter
setup
SETUP
Syxz
Wodj

OTHER BIOS PASSWORDS BY MANUFACTURER

Manufacturer Password
VOBIS & IBM merlin
Dell Dell
Biostar Biostar
Compaq Compaq
Enox xo11nE
Epox central
Freetech Posterie
IWill iwill
Jetway spooml
Packard Bell bell9
QDI QDI
Siemens SKY_FOX
TMC BIGO
Toshiba Toshiba

TOSHIBA BIOS

Most Toshiba laptops and some desktop systems will bypass the BIOS password if the left shift key is held down during boot

IBM APTIVA BIOS

Press both mouse buttons repeatedly during the boot


--------------------------------------------------------------------------------

Password cracking software

The following software can be used to either crack or reset the BIOS on many chipsets. If your PC is locked with a BIOS administrator password that will not allow access to the floppy drive, these utilities may not work. Also, since these utilities do not come from the manufacturer, use them cautiously and at your own risk.

Cmos password recovery tools 3.1
!BIOS (get the how-to article)
RemPass
KILLCMOS

--------------------------------------------------------------------------------

Using the Motherboard "Clear CMOS" Jumper or Dipswitch settings

Many motherboards feature a set of jumpers or dipswitches that will clear the CMOS and wipe all of the custom settings including BIOS passwords. The locations of these jumpers / dipswitches will vary depending on the motherboard manufacturer and ideally you should always refer to the motherboard or computer manufacturers documentation. If the documentation is unavailable, the jumpers/dipswitches can sometimes be found along the edge of the motherboard, next to the CMOS battery, or near the processor. Some manufacturers may label the jumper / dipswitch CLEAR - CLEAR CMOS - CLR - CLRPWD - PASSWD - PASSWORD - PWD. On laptop computers, the dipswitches are usually found under the keyboard or within a compartment at the bottom of the laptop.
Please remember to unplug your PC and use a grounding strip before reaching into your PC and touching the motherboard. Once you locate and rest the jumper switches, turn the computer on and check if the password has been cleared. If it has, turn the computer off and return the jumpers or dipswitches to its original position.


--------------------------------------------------------------------------------

Removing the CMOS Battery

The CMOS settings on most systems are buffered by a small battery that is attached to the motherboard. (It looks like a small watch battery). If you unplug the PC and remove the battery for 10-15 minutes, the CMOS may reset itself and the password should be blank. (Along with any other machine specific settings, so be sure you are familiar with manually reconfiguring the BIOS settings before you do this.) Some manufacturers backup the power to the CMOS chipset by using a capacitor, so if your first attempt fails, leave the battery out (with the system unplugged) for at least 24 hours. Some batteries are actually soldered onto the motherboard making this task more difficult. Unsoldering the battery incorrectly may damage your motherboard and other components, so please don't attempt this if you are inexperienced. Another option may be to remove the CMOS chip from the motherboard for a period of time.
Note: Removing the battery to reset the CMOS will not work for all PC's, and almost all of the newer laptops store their BIOS passwords in a manner which does not require continuous power, so removing the CMOS battery may not work at all. IBM Thinkpad laptops lock the hard drive as well as the BIOS when the supervisor password is set. If you reset the BIOS password, but cannot reset the hard drive password, you may not be able to access the drive and it will remain locked, even if you place it in a new laptop. IBM Thinkpads have special jumper switches on the motherboard, and these should be used to reset the system.


--------------------------------------------------------------------------------

Overloading the KeyBoard Buffer

On some older computer systems, you can force the CMOS to enter its setup screen on boot by overloading the keyboard buffer. This can be done by booting with the keyboard or mouse unattached to the systems, or on some systems by hitting the ESC key over 100 times in rapid succession.


--------------------------------------------------------------------------------

Jumping the Solder Beads on the CMOS

It is also possible to reset the CMOS by connecting or "jumping" specific solder beads on the chipset. There are too many chipsets to do a breakdown of which points to jump on individual chipsets, and the location of these solder beads can vary by manufacturer, so please check your computer and motherboard documentation for details. This technique is not recommended for the inexperienced and should be only be used as a "last ditch" effort.


--------------------------------------------------------------------------------

Using a professional service

If the manufacturer of the laptop or desktop PC can't or won't reset the BIOS password, you still have the option of using a professional service. Password Crackers, Inc., offers a variety of services for desktop and laptop computers for between $100 and $400. For most of these services, you'll need to provide some type of legitimate proof of ownership. This may be difficult if you've acquired the computer second hand or from an online auction.


--------------------------------------------------------------------------------

Links to Motherboard Manufacturers

If you need additional documentation about your motherboard, location of jumpers / dipswitches, location of the battery, BIOS settings, etc., we've included links to most of the major motherboard manufacturers here.

2 the Max
A-trend
Abit
American Megatrends
Amptron
Aopen
ASUS
Biostar
Chaintech Concord
Elite Computer Systems
Epox
FIC
Freetech
Giga-Byte
IBM
Intel Magic-Pro
Matsonic
Microstar
PC Chips
QDI
Siemens
SuperMicro
Tyan


--------------------------------------------------------------------------------
 
Dell Laptop Password

Dear Friend

Thanks for sum Information about Laptop Password

Please can u healp me my laptop Password, I have Dell Inspiron 8000, Protected by a Password {Primary or Administrator Password} Bios password. If possible can u give me information how to go around. I can work Part's Lavel (Ex. TV -VCR Reparing)

Thanks
 
For phoenix passwords have a look at the BIOS thread on the sticky.

For thinkpad bios password, mate thats near enough impossible. IBM security is very hard to crack.
 
Back
Top