Motor Setup S10

I am trying to set up a s10 with a TM-2600 motor. I had to get a new motor as the old one died (used a 500s then). The motor has been set up and recieves 28.2 as per channel file I put on box. I have added 13.0 and 19.2 in the satellite list and activated them or ticked them. I have set the motor as diseq 1.2 on all satellites. I have then stored 13.0 and 19.2 in positions.

I have set LNB frequency to universal for both but cant get either to change transponder. The message No TP is there with no other options. The signal intensity is 44% and quality is 10% on both. I have tried moving manually in motor settings but there is no budge in signal strength. HELP!!!

Is it posible to upload via usb an image with correct motor settings?

no matter the box u need set ur dish to thor 1w(bbc world news)
with everything straight,ie motor set at zero wiith dish straight
ive not used that box but if enigma 2
you could put on stgflipflop multi channel list and that will
give u sats needed.
if using usuals enter lat and longitude and if ur dish was aliingned properly on thor
then it willfind the other sats on the arc.

I put it to single sat scan and done a blind scan and it picked them up. The fact the signal level didnot change in the antenna setup was throwing me. Cheers, John.

Tried adding other satellites and fecked it up. Could n't get the box to find sat and store using diesq 1.2. The box was storing 19.2 on 28.2. Tried moving to usals and it was finding 13.0e on 7.0e. It now has 19.0, 13,0 and 28.2 all stored 6 degrees less than they are ie 28.2 = 22.2 on the box, 19 = 13 on the box and 13 is sored as 7 on the box. Anyone know why? The box had 28.2 as 28.2 previously so the motor should be set fine?