Help !!!! -

Hi Edogg.
This software i have.
I Need the software with opcion menu - RS232. because my STB is dead (only ON in the display ) and not receive the firm by RS 232. stb memory error this is a messagem from Emrom.
Many tks.
Naxa - São Paulo - Brasil
 
yes. You need the software edogg has shown you the link for, I have also attached it.
Plug this into your box using an RS232 lead. Select the required firmware and flash the box using RS232.
 
From what I can make out from his post, it looks like he's already using that software but is receiving an "STB Memory Error"

Sounds like the same issue i originally had and he just needs to make sure his cable is sound or he's following the instructions to the letter.
 
Hi Edogg.
This software i have.
I Need the software with opcion menu - RS232. because my STB is dead (only ON in the display ) and not receive the firm by RS 232. stb memory error this is a messagem from Emrom.
Many tks.
Naxa - São Paulo - Brasil

hi naxa there is not any software with that menu option you need to connect your openbox with it turned off the supplied software running on your computer select the firmware to update with click connect and turn the openbox on if you get error turn the open box off click connect and turn on the openbox repeat this until it connects and downloads the firmware

edogg
 
Thanks to all who responded.
I found the problem, bad contact in the motherboard did not allow the inclusion of the software.
Now I am trying to locate the problem, since often it is ON.
Many tanks for all.
Naxa - Sao Paulo - Brasil
 
Back
Top