FUNCARD with CR1 NEED SOME HELP!!!!

gforce83

Inactive User
Joined
May 7, 2005
Messages
65
Reaction score
0
Hi

I did a seach but couldn't find any info on this.

What it is, i have a pace 1000 box with CR1 on it but it doesn't seem to auto upgrade itself to CR3 (not to bothered about that) its just my funcard wont AU the keys. I am using flash file V3 and i'm wondering whether its not compatable with CR1? I have left it for 30 minutes but still wont update the keys!!

I have entered the keys manually and all is ok, but i would like it to AU! my other 1000 box with CR3 works fine with the same files!!

(I have force the box to update but its been doing it for over 2 hours any ideas how long it takes?)

Thanks
GForce
 
Sound like u got a anti up date done .. open it up and remove it

the wire from the atmel to the battry . just cut it don't try 2 remove it totaly as u might brake the leg off the chip. clean the sim conntacts to while ur in there and push it down good.

power up and force update.

if ur in T/* CR1 will no longer update
 
Sound like u got a anti up date done .. open it up and remove it

the wire from the atmel to the battry . just cut it don't try 2 remove it totaly as u might brake the leg off the chip. clean the sim conntacts to while ur in there and push it down good.

power up and force update.

if ur in T/* CR1 will no longer update

Thanks for the reply

I have opened it and the atmels are in tacked and hevent been tampered with there is no wire or nothing but the box is still going through the update. I am in ex CW area.
 
Thanks for the reply

I have opened it and the atmels are in tacked and hevent been tampered with there is no wire or nothing but the box is still going through the update. I am in ex CW area.

actually with a closer inspection (using a magnifying glass) it look like the atmels have been lifted and replaced. underneath the right atmel there is a slight burn mark that could be over some tracks on the circuit board!! will this stop the box from updating??
 
Back
Top