amiko lx 800
- Thread starter beano2
- Start date
Check you have sent the correct mac code
This could be different when using wifi as opposed to ethernet and visa versa.
This could be different when using wifi as opposed to ethernet and visa versa.
You say you selected a bin file and pressed 2822 was that to update your firmware ?
Have you then opened the mytv app and inserted the url ending in /c/ in to the portal settings ?
Have you then opened the mytv app and inserted the url ending in /c/ in to the portal settings ?
No its /c/ not /c
Also you can add m3u lines on the LX make sure you use portal 1
And go over your line and make sure you have made no typos.
Make sure it is actually connected to the net not assume.
These boxes work fine it has to be a setup issue or the line.
Where did you take the mac address from lable on base of the box or from the app MyTV ?
Also you can add m3u lines on the LX make sure you use portal 1
And go over your line and make sure you have made no typos.
Make sure it is actually connected to the net not assume.
These boxes work fine it has to be a setup issue or the line.
Where did you take the mac address from lable on base of the box or from the app MyTV ?
let us know we will get this sorted !
Are you setting up under Portal 1 mate ?
Is your mac address showed correctly in that portal ?
By the way the latest version of software is 2.0.3.0. so you should probably run the update and try again.
Is your mac address showed correctly in that portal ?
By the way the latest version of software is 2.0.3.0. so you should probably run the update and try again.
Try using the net upgrade feature it should be on the front page opposite lower corner from the mytv app
