Zgemma h2s jtag

I have found Broadband Studio 3 and BCM 97632 as well as a few others thanks to Ferret for his tut on the Cloud boxes :Clap: but having followed the tut by loading BBS 3 on WinXP then plugging in the Cypress USB board it does not find or load any drivers so shows as "disconnected" when its all hooked up to the zgemma h2. I have tried and tried, even read another tut in Italian that said to use the "unistdriver" included in Ferrets files but still no joy. Can anybody shed light on the prob as I have learnt as much as I can but need a little help. :silly:
Hi please you share with me the BCM97362 and BBStudio. i Have the Cypress Board and i searched for a lot of days and not find this programs.

Thank you in advance
 
I will try to attach it for you. I think the BCM97362 is in the zip.
Newly thank you but not come BCM97362, only come BCM97358 and not is for Zgemma H2S, maybe that you have lost the file in your pc, hehe

If you find it BCM97632, please share it. Thanks for all
 
Hi, did any one find the BCM97362 files. i need to jtag gigablue ultra ue which has the same chip but cannot find anything.
thanks
 
Hi all guys...I am writing on this slightly dated thread to know if you have the bcm7362.msi file to be able to recognize the zgemma h2h...I have this bricked decoder and without that file I cannot flash it with bbs3.1...thank you all for any help or answer!
 
Hi all guys...I am writing on this slightly dated thread to know if you have the bcm7362.msi file to be able to recognize the zgemma h2h...I have this bricked decoder and without that file I cannot flash it with bbs3.1...thank you all for any help or answer!
Should be able to recover it with a usb flash
 
Thanks for the reply ... would you know how or someone could fsr it for me? Thank you
 
hello everyone, in your opinion, with orca or other msi file editor, I could modify the bcm7358 file (driver for bbs of cib3) in a file bcm7362 (driver for bbs of zgemma h2h)? Thank you guys
 
hello everyone, in your opinion, with orca or other msi file editor, I could modify the bcm7358 file (driver for bbs of cib3) in a file bcm7362 (driver for bbs of zgemma h2h)? Thank you guys
Just flash it from a usb or get a new box. The h2h is really old as much better ones about for a reasonable price
 
Unfortunately, a flash is not enough...the box remains with the rossk led on and no writing...after place (if I can) the screens of the ft232 response...if there is any other procedure to do, I would thank you very much if let me know in detail how.
 
Any luck? I got a dead Gigablue X2, it has also an BCM7362 processor...
 
Using the UART? I checked this port but there is no activity either on this port.
 
Using the UART? I checked this port but there is no activity either on this port.
As you suspect bootloader is corrupt, i can not help with the BCM file your after though they were on my windows 7 drive SSD but it died, if i find them ill be sure to let you know.
 
Back
Top