hi i have finally got my rs232 and connected to my pc and is working fine in hyperterminal.
i have followed the steps in the tutorial.
letting the modem boot up and entering the non update commands. (with and without the signal cable connected)
but all the modem keeps doing is the startup boot sequence and not stopping at the command line prompt CM>
i am definately using lowercase also. as i know problems occur with case.
also i have tried typing out the whole thing and also pasting but not getting any luck ??!
so what am i doing wrong ?
what happens is it stops for a second and gives options of pressing "1" "2" or "p" or leave it to load default
and all this ever does is start scanning all the frequencies.
im so close yet so far...
i have followed the steps in the tutorial.
letting the modem boot up and entering the non update commands. (with and without the signal cable connected)
but all the modem keeps doing is the startup boot sequence and not stopping at the command line prompt CM>
i am definately using lowercase also. as i know problems occur with case.
also i have tried typing out the whole thing and also pasting but not getting any luck ??!
so what am i doing wrong ?
what happens is it stops for a second and gives options of pressing "1" "2" or "p" or leave it to load default
and all this ever does is start scanning all the frequencies.
im so close yet so far...