the NO CA FOUND error

amro

Inactive User
Joined
Aug 28, 2011
Messages
6
Reaction score
0
I need help, my DM800 HD PVR is not booting anymore it just keep showing the NO CA FOUND error.

*The problem, I did flash it with a wrong .nfi or firmware, but before I did that, it was detecting a DM7020 as firmware though my unit shows DM800 HD PVR and make suitable firmware then all thing is OK.

Now, I need to know which method to re-software firmware Because com port (serial) not detected throw Dream-UP ....... What the solution??????
 
Thanks for reply,
but still no solution :grayno:
 
best get reading through the 800 section then, there was a post from philsbox who had the same error, and a solution to fix it but i cant find it, sorry!
 
I did also but no new !!!! I need some help :(((
 
have you tried connecting through ethernet cable then flashing through the web interface, switch box off then hold power button on front of box while plugging power back in, then while still holding power, wait until an ip shows on front display of box then let go of power, then goto your browser and type the ip address in, this should bring up your dm800 web interface where you can flash the right firmware from there, hope this helps!
 
have you tried connecting through ethernet cable then flashing through the web interface, switch box off then hold power button on front of box while plugging power back in, then while still holding power, wait until an ip shows on front display of box then let go of power, then goto your browser and type the ip address in, this should bring up your dm800 web interface where you can flash the right firmware from there, hope this helps!

I did before and done....but now DM800 not response Rs232 by Dream-UP
 
are you using the 2nd stage dreamup!

theres a couple of different methods in the pack i think.
 

Attachments

  • 2nd_stage_pack.zip
    4.2 MB · Views: 52
You need to use patched dreamup for DM800 clones. Also what SIM version and bootlaoder was on hte box before you flashed the incorrect image ? What image and bootlaoder did you try to flash with that caused the issue ?
 
You need to use patched dreamup for DM800 clones. Also what SIM version and bootlaoder was on hte box before you flashed the incorrect image ? What image and bootlaoder did you try to flash with that caused the issue ?
The SIM version 2.01
bootlaoder 72

the other bootlaoder I tried to flash with that caused the issue maybe DM7025
 
run dreamup , connect DM800 with cable
under dreamop select network and in the remote ip (box) put the ip you want for your box
now switch on the dreambox, dreamup will prepared the box for flash
when ready for flash
take the remote ip (box) then follow the procedure through the web now
192,168.xxxx.xxx
will get to the upgrade firmware page the try the image you want
 
Back
Top