VU+ Solo2 Lonrisun Clonesafe Images (for use with v4 flash only) - April 2015 updates

ketmp

Satellite Moderator
Staff member
Moderator
Joined
Sep 16, 2014
Messages
2,601
Reaction score
1,674
Lonrison Clonesafe Images (for use with v4 flashed clones only)


These images are for use with v4 flashed boxes only. If you haven't got a v4 flashed box or you are not sure what flash version you have, do
NOT use these images as it is very likely it will brick your box. You have been warned.


I recommend backing up your current image first before flashing with these images and I recommend not doing a restore of any previous settings

These drivers have the drivers confirmed as clonesafe (with v4 flashed boxes). Due to these drivers being old, some features may not work or work as intended and XBMC support and animated screens are two such features.

These images have the driver version patch and drivers write-protected already applied but I still advise against doing an online update. Any updates done are at your own risk as it may cause bricked box!

I take no responsibility for any bricked boxes or other problems due to using this image. Use these images at your own risk!


Remember these images are for use only with boxes known to be using v4 flash update.

Code:
You don't have permission to view the code content. Log in or register now.

* These images are done via an online update from an older version before introduction of XBMC and animated screens. Therefore, these images may be unstable due to significant code changes.

** This image is currently the latest one that is supported for Lonrison clones due to BH introducing XBMC as standard (rather than a plugin like on few other images).


 
Last edited by a moderator:
I've tried all of these, I had tuner scanning problems with Openvix Apollo 163 and it doesn't seem to deep shutdown.

OpenATV has the same Deep shutdown problem and all the rest seem fine, tested with a Lonrison V4. XBMC plugin does not work.
 
The deep shutdown problem is caused by the drivers not supporting gles while enigma2 uses it.

That makes the box crash at shutdown which causes it to reboot instantly ...
... so no shutdown possible anymore.

For Lonrisun V4 you can use one of my images that i regularily update

Code:
You don't have permission to view the code content. Log in or register now.

There is also an upload of one of my OpenViX images

Code:
You don't have permission to view the code content. Log in or register now.
 
Last edited by a moderator:
I'm testing this now as we speak and it is superb, the shutdown problem has been taken care of and its scanning which is great, Thank You. :)
 
Hi guys, I have a Solo2 lonrisun clone which is currently on OpenVix build 029. Could you help me find out if I have a V4 flashed box? I did some googling but couldn't find any help
 
Last edited:
Hi guys, I have a Solo2 lonrisun clone which is currently on OpenVix build 029. Could you help me find out if I have a V4 flashed box? I did some googling but couldn't find any help

There is no real way of knowing if in doubt run the v4 upgrade it wont hurt to upgrade it again ig it is already on v4.
 
ah ok, I will give that a try. Is the update in the downloads section and will I lose my image/data if I run the update?

Thanks for the help!
 
ah ok, I will give that a try. Is the update in the downloads section and will I lose my image/data if I run the update?

Thanks for the help!

Well if you want to keep the image you have now there is no real point running the V4 update. just backup you settings to use later on any new v4 image you use.
 
Back
Top