HI,
I have a strange problem with ethernet port in my Nokia D2 2xIntel.
When I plug in crossover cable connection is showing, but there is no answer for ping, etc.
Connection is direct between pc and dbox of course.
My network setting:
PC -> ip 192.168.1.3 mask 255.255.255.0
dbox -> ip 192.168.1.2 mask 255.255.255.0
Connection is showing as 10mb/s - it's correct for dbox maximum transmission speed.
I flased my dbox by hyperterminal an null modem cable, because bootmanager and ifa, they not working with my "broken" lan.
When I plugged ethernet cable (simple 1->1 cable of course) into my router there is no ip also (no matter static or dhcp).
I checked some resistors in ethernet pcb corner:
RE4 i RE5 - should be 49R9 (prawie 50 ohm) , on my board both are 25,5 ohm
RE7 i RE8 - should be 75R (75 ohm), both are 68,8 ohm
RE6 i RE9 - should be 37R4 (37,4 ohm), both are 36,3 ohm.
Should I change RE4 and RE5 only?
Or mayby is something wrong with chip TRE1 or TE1?
Thank you.
I have a strange problem with ethernet port in my Nokia D2 2xIntel.
When I plug in crossover cable connection is showing, but there is no answer for ping, etc.
Connection is direct between pc and dbox of course.
My network setting:
PC -> ip 192.168.1.3 mask 255.255.255.0
dbox -> ip 192.168.1.2 mask 255.255.255.0
Connection is showing as 10mb/s - it's correct for dbox maximum transmission speed.
I flased my dbox by hyperterminal an null modem cable, because bootmanager and ifa, they not working with my "broken" lan.
When I plugged ethernet cable (simple 1->1 cable of course) into my router there is no ip also (no matter static or dhcp).
I checked some resistors in ethernet pcb corner:
RE4 i RE5 - should be 49R9 (prawie 50 ohm) , on my board both are 25,5 ohm
RE7 i RE8 - should be 75R (75 ohm), both are 68,8 ohm
RE6 i RE9 - should be 37R4 (37,4 ohm), both are 36,3 ohm.
Should I change RE4 and RE5 only?
Or mayby is something wrong with chip TRE1 or TE1?
Thank you.