3D Printing epson R265 printer

got an old Epson R265 printer used it for years with continuous ink had no problems went to use it on sunday was not printing properly tried head cleaning nozzle check etc but no good so decided to stick my hand in and clean with a baby wipe several minutes later tried to use it it says imcompatable ink tried to sort it but when it gets to charge ink it just comes up replace imcompatable ink is there anything I can do or is it time to get a new printer




thanx for looking

There used to be something knocking about called "SSC Service Utility
for Epson Stylus Printers"

That could work for you, I think it resets the printer.

had a look and found this @derek12345 m8

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

give that a bash and hope it solves your problem ?

no good spud wont recognise the ink thanks anyway

Will it not work with the original inks neither?.

try checking the heads on the printer there my still be something stuck in. i would recommend cleaning again with proper printer cleaning products. i tend to use AF Platenclene Cleaning Pump Spray works a treat for servicing and cleaning heads