skybox f3

Dolfiemax

Member ++
Joined
Mar 16, 2005
Messages
872
Reaction score
20
Location
Cardiff
got a couple of these one downstairs and 1 in bedroom - all working fine but as im on motorized set up my downstairs will switch between satellites but upstairs wont switch at all - a mate said something about only 1 will be master and 1 will be slave which means only 1 can control dish but i was going to change to another output on lnb but am i wasting my time is this right - i also have a spiderbox and seemed to remember something like disecq swithes would this be something that enables both boxes to control dish as sky boxes dont have this in softwsre - cheers
 
could i split the f connector than controls motor - other than a possible hinderance of signal shouldnt this allow both boxes to work motor?
 
In theory this would work but i think in practice you will end up blowing your motor u have to be soo careful
 
I can see where your coming from as far as a possibility of 2 boxes fighting over which sat but in my case both boxes arnt active at same time so would think should be ok
 
Hey Guys,
can anyone please help me how to setup a skybox f3 to a satellite that is motorized and im new to this box.
 
Hey Guys,
can anyone please help me how to setup a skybox f3 to a satellite that is motorized and im new to this box.

ask in the openbox section and have a read around the forum as there are guides on how to set boxs up,regards mdt
 
Thank you MDT,

i'm not sure how to setup motor configuration in skybox f3.
 
write this from your usb not sure which 1 but has astra 28/19 and hotbird with channel db make sure you back up your 1st in case not for you
 

Attachments

  • Desktop.rar
    200.3 KB · Views: 5
Under satellite settings check the motor settings are on, use usals, then select the sats you want to use and the dish 'should' turn to the one selected.
 
new to this guys hope to get some help got a sky f3 box hopeing some one will show me the ropes:Biggrin2:
 
Back
Top