I have had my Skybox F3 for quite a few day now.
When purchasing my box i looked on a few forums to try and get an idea of how difficult it would be to set up.
whilst looking i found out that i would have to...
)update firmware
)Connect to wireless
)get CCcam on USB to upload
no problem..... I thought!!!!!
What i want.....
I want to have my Skybox f3 ready to put my CCcam in (when acquired)
What i have done....
Since getting the box through i seem to have spent days scrolling through information to see if anything can help me with the setup.
Where am i stuck....
WELL I have updated my box through USB with THE NEXT GENERATION 2 firmware,
I then went on to try to use a Realtek RTL8191SU wireless network adapter to connect my Virgin Super HUB,
However the Skybox would not even identify that the dongle was attached to the box even though i have made sure that WPA was set to WPA and not set to WPA/WPA2 on the HUB, so i just moved my HUB next to the Skybox F3 to connect through ethernet cable.
But what should i be doing now?
How do i know if the ethernet is connected properly?
I hate to trouble people for help but there is so much conflicting information and it seems as if only bits apply to me!
Any help that anyone leaves me is Greatly Appreciated.
When purchasing my box i looked on a few forums to try and get an idea of how difficult it would be to set up.
whilst looking i found out that i would have to...
)update firmware
)Connect to wireless
)get CCcam on USB to upload
no problem..... I thought!!!!!
What i want.....
I want to have my Skybox f3 ready to put my CCcam in (when acquired)
What i have done....
Since getting the box through i seem to have spent days scrolling through information to see if anything can help me with the setup.
Where am i stuck....
WELL I have updated my box through USB with THE NEXT GENERATION 2 firmware,
I then went on to try to use a Realtek RTL8191SU wireless network adapter to connect my Virgin Super HUB,
However the Skybox would not even identify that the dongle was attached to the box even though i have made sure that WPA was set to WPA and not set to WPA/WPA2 on the HUB, so i just moved my HUB next to the Skybox F3 to connect through ethernet cable.
But what should i be doing now?
How do i know if the ethernet is connected properly?
I hate to trouble people for help but there is so much conflicting information and it seems as if only bits apply to me!
Any help that anyone leaves me is Greatly Appreciated.