Pin Stuck in Service Menu

Sencore

Inactive User
Joined
Mar 18, 2007
Messages
222
Reaction score
3
Location
On cloud 9
Hi all, can someone please tell me how to enable/change the pin in the service menu of a Pace DI4010N box? I swapped mine for this box and don't know the pin and when I go in the service menu I can't change it.
 
if you want to change the pin you have to pull the red jumper, which is located inside the box. once you have done that hold up and down and power up the box and you'll go into the eng menu where you can change the pin and press service and restart the box and it should be done.
 
Thanks jonny, when i take out the red jumper should the box be off or on.
Then when the red jumper is off do I start the box with/without it or how long should I wait before plugging the jumper back in.
Do I need to know my ID or anything else? or the box will remember it.
Thanks again
 
sencore

the box should be off before you pull the red jumper, wait atleast 5 minutes before putting the red jumper back on,

connect the box to libby with the appropriate config file and set network i,d to your area. once this has been done you need to go into engineers menu by holding up and down key on front of your box whilst plugging power in after you see - - - - on the box lcd it shud boot to engineers where you should see the pin in 0000 set it to your liking and save it by pressing tv key

always make sure the network i,d is correct on the 2nd page

hope this helps
 
if you have a 4010n using it in pure n*l you don't need to use libby to set the pin only through the eng menu and press service and it will store.
1)switch boxs off
2) pull the jumper wait about 5-10 min
3) put the jumper back on
4) start the box up while holding up and down
5) change pin on page 2 of eng menu and press service to store
6) reset the box
7) and enjoy

But if you after the movies you need to jtag it with the macro hope this helps
 
if you have a 4010n using it in pure n*l you don't need to use libby to set the pin only through the eng menu and press service and it will store.
1)switch boxs off
2) pull the jumper wait about 5-10 min
3) put the jumper back on
4) start the box up while holding up and down
5) change pin on page 2 of eng menu and press service to store
6) reset the box
7) and enjoy

But if you after the movies you need to jtag it with the macro hope this helps
Pure n*l area. Yes I'm after the movies, it only let me watch it after nine so I thought it would be just a matter of changin the pin and not jtaging. On the subject of it what is the name of the macro to use for it ? I do have the ocd prog.

Thanks jonny and thanks to paimai as as well
 
i think it is called 4000 an you can find it somewhere here lol i belive i haven't tried it yet but will do so when i get a jtag
 
Ok thanks, so even though I can enter the pin it wont let me see the movies in normal times? Am I correct? If I decide to jtag would you know which one I should get?

Thanks again
 
its worth a go m8 i wouldnt knock it. if it doesn't work try tmc for the jtag or fleabay
 
Back
Top