Just found this on the mythtv website - any use? (taken from the page FAQ page on
www.mythtv.org)
23.20 Using the DBoxII within MythTV
The configuration of the DBoxII for use within MythTV is tricky (as of May 16 2005), that's why it's covered here. Your DBoxII has to be running linux and the Neutrino GUI instead of the stock BetaNova firmware. For further information, please refer to
http://www.tuxbox.org. Additionally, you need to enable the SPTS mode in Neutrino.
* Add a new "Capture Card" in the setup. The "Card type" is "DBOX2 Input", the other values have to be adjusted according to your setup. The default values, except for the "DBOX2 host ip", should work fine.
* Define a new video source. It doesn't need to be configured, you just need to define it. MythTV grabs the EPG from the DBoxII.
* Connect the DBoxII to the newly defined input source in "input connections".
* Since channel scanning is not implemented yet, you need to define channels in the "Channel Editor". Make sure that you use the same value for "Channel Name" as on the DBoxII. You can get a list of available channels from the web interface of Neutrino at
http://ip-of-your-box:80/. Associate the channel with your new video source and repeat when needed.
You may leave the Setup now and proceed as usual.