dm800hdse image

melttc said:

Hello Guys

what I am looking for is an image for my dm 800se , I currently have jamesyboyjims pli4 image on which works but I have to restart the cam after every boot up to get it working and for some reason it always goes into to standby mode.

what I would like if possible is one I can just flash from browser with the sl84 bootloader built in and epg and tsmedia and anything good like that.
Can anyone recommend a good solid working image please.............

P.S thanks jamesyboyjim for that image it was a great image and maybe the problems are on my end so don't let this put any of you off using it.

thanks.

Click to expand...

Ferret said:

Before you give up on your image take a look at your mg_config and see if your settings are the same as these.

G:{ 01 }
P:{ 00 }
B:{ 06 }
R: { 01 }


If not try them.

Click to expand...

Ferret said:

Before you give up on your image take a look at your mg_config and see if your settings are the same as these.

G:{ 01 }
P:{ 00 }
B:{ 06 }
R: { 01 }

If not try them.

Click to expand...

bbbuk said:

Try the following. I got this courtesy from another forum but I can't confirm whether it works as I don't have cable line to test but I found it in cable section of another forum.

You could save what you have got as a backup and try this instead. If no good, then go back again.

Code:

You don't have permission to view the code content. Log in or register now.

Click to expand...

Ferret said:

Thats not going to work it is setup for a dbox for one.

Click to expand...

bbbuk said:

The Box type is set to 2 for dreambox (or should it be 6 for Dreambox HD)?

Click to expand...

Abu Baniaz said:

Should be 06 for MIPS (DM800, Vu Duo, TM Twin, Xtrend et6500 etc)

Click to expand...

Abu Baniaz said:

From where and when did you get your cam?

Also which image are you now using?

Click to expand...