witchy
Banned for good!
- Joined
- Jul 20, 2005
- Messages
- 18,282
- Reaction score
- 334
I bought a new Techomate 2600 today and it's all installed nicely (cough).
I load up Black Hole 0.12 on my DM800 and go into the 'service searching' page in sertup.
I go into Tuner config and I select the satellites I want to scan and I chose DiSeqC 1.2, I then save changes and come out and then I tell it to Auto-Scan, but nothing happens. :err: - Dish doesn't move or even try to move.
Also, if I go into Positioner Setup and tell it to manually move the dish East or West or even to 0 degs, it does fook all, it just sites there.
If I go out to the motor/dish the green light is on and I can move the motor no problem using the button under it.
This is the first time I've used an E2 box, so hopefully I'm missing something, but from where I stand, this is yet another problem with my DM800.
So, can some kinds person please give me a step by step guide on how to setup a motor on an E2 image, preferable Nabolisat Black Hole.
I load up Black Hole 0.12 on my DM800 and go into the 'service searching' page in sertup.
I go into Tuner config and I select the satellites I want to scan and I chose DiSeqC 1.2, I then save changes and come out and then I tell it to Auto-Scan, but nothing happens. :err: - Dish doesn't move or even try to move.
Also, if I go into Positioner Setup and tell it to manually move the dish East or West or even to 0 degs, it does fook all, it just sites there.
If I go out to the motor/dish the green light is on and I can move the motor no problem using the button under it.
This is the first time I've used an E2 box, so hopefully I'm missing something, but from where I stand, this is yet another problem with my DM800.
So, can some kinds person please give me a step by step guide on how to setup a motor on an E2 image, preferable Nabolisat Black Hole.