Ok so i'm getting my Penta85 mounted tomorrow with a TM2300.
Hopefully this will be a painless exercise but i just want to see what peoples opinions are on how i should go about the task.
I currently have BH012 on my clone dm800 and my plan is to do as follows:
As this is my first motor dish install i'm hoping it as easy as that, but i have a few questions which hopefully some can help with.
Is the above methodology the easiest way to go about it (ie, install channel list 1st)?
Would 1W be the best for me to try to locate first (i'm based in north east, post code sr8)?
When i talk about fine tuning the dish to get strongest signal should this be done by tweaking dish manual on brackets or by jogging the motor from the dm800?
When one sat is found should the dish then aout find the other ones if i'm using simple mode and long/lat setup?
Any help and thought much appreciated.
Cheers
S
Hopefully this will be a painless exercise but i just want to see what peoples opinions are on how i should go about the task.
I currently have BH012 on my clone dm800 and my plan is to do as follows:
- Install Likra channel set on my dm800.
- Once dish is installed and connected to dm800 input long/lat from sat nav data or multimap.
- Try and locate 1W and fine tune dish till best signal is obtained.
- See if other sats are then auto picked up.
As this is my first motor dish install i'm hoping it as easy as that, but i have a few questions which hopefully some can help with.
Is the above methodology the easiest way to go about it (ie, install channel list 1st)?
Would 1W be the best for me to try to locate first (i'm based in north east, post code sr8)?
When i talk about fine tuning the dish to get strongest signal should this be done by tweaking dish manual on brackets or by jogging the motor from the dm800?
When one sat is found should the dish then aout find the other ones if i'm using simple mode and long/lat setup?
Any help and thought much appreciated.
Cheers
S