*The problem, I did flash it with a wrong .nfi or firmware, but before I did that, it was detecting a DM7020 as firmware though my unit shows DM800 HD PVR and make suitable firmware then all thing is OK.
Now, I need to know which method to re-software firmware Because com port (serial) not detected throw Dream-UP ....... What the solution??????
Thanks for reply,
but still no solution
best get reading through the 800 section then, there was a post from philsbox who had the same error, and a solution to fix it but i cant find it, sorry!
I did also but no new !!!! I need some help ((
have you tried connecting through ethernet cable then flashing through the web interface, switch box off then hold power button on front of box while plugging power back in, then while still holding power, wait until an ip shows on front display of box then let go of power, then goto your browser and type the ip address in, this should bring up your dm800 web interface where you can flash the right firmware from there, hope this helps!
are you using the 2nd stage dreamup!
theres a couple of different methods in the pack i think.
You need to use patched dreamup for DM800 clones. Also what SIM version and bootlaoder was on hte box before you flashed the incorrect image ? What image and bootlaoder did you try to flash with that caused the issue ?