n line mgcamd

scott-ayling

VIP Member
VIP Member
Joined
Jun 8, 2005
Messages
1,226
Reaction score
34
i currently use cccam with a n line but i have been told mgcamd is better to use but i tried to setup but no luck anyone post an idiots guide heres my n line (edited of course)

N: 27.123.54.203 37656 xerq7l9 neiergiwq 11 02 12 18 95 09 44 13 65 05 21 73 35 09
 
every time i edit the newcamd.list and save it and re-open it to check it its just blank think ill give up cccam is working ok but i was told i would get better ecm times with mgcamd
 
I run an oscam server with clients connecting using cccam and mgcamd to connect to both camd35 and newcamd protocols and I have seen absolutely no difference in reliabilty or ecm times at all
 
Hi , i been using mgcamd 1.35a from a oscam server, it is a big difference for me over using cccam, its been perfect not a single glitch for week now :) thats how good, in newcamd.list put it in like this

CWS_KEEPALIVE = 300
CWS = this is your line take away the N:

i didnt have the CWS_KEEPALIVE = 300 in before and it would idle the mgcamd after viewing a fta channel for awhile,

make sure you activate mgcamd in blue settings
 
every time i edit the newcamd.list and save it and re-open it to check it its just blank think ill give up cccam is working ok but i was told i would get better ecm times with mgcamd

How do you edit the newcamd.list file ?
 
every time i edit the newcamd.list and save it and re-open it to check it its just blank think ill give up cccam is working ok but i was told i would get better ecm times with mgcamd

i use FTP flash, and open selecting edit and save
 
Got it too work i used flashfxp instead of dreambox control centre and it worked
 
Maybe a stupid statement but with DCC you have to click the small floppy/save icon in the toolbar rather then simply closing the file. Closing the file without clicking the little icon simply abandons the change(s).
 
Just to say - needed this info - quick search brought me here and its spot on!! Thank you!!
 
Back
Top