hi all i got a 2100 hear that will not find its net id or frequancy ,
i shorted battrey
and now have net id 099999 or somthing like,with wrong freq for my area
wen i plug into stream it stays at ld20 left it overnight to take update but still lb20 with wrong freq and id ??
set freq in e/m manulay to see if it would then find id and tune but freq just defaults back on reboot and id stays at 0999999


any ideas please ???? tia.

(anyone think this is tuner fault?)

what area are you in rg ntl,c/w or tw

pure ntl m8

The frequency can be set for your area in the engineers menu.

You will need to set the NetID to your area. You can do this by writing a funcard with special instructions that set the NetID force the box to reboot and then the new netid takes effect.

I suggest starting with a search on these forums for "netid funcard" and see what you get

The netid and frequency values should also be available within these forums somewhere...

why have i never needed to do thids b4 timbo????

i know what my net id and freq should be m8 and like i said in the first post i have tryed to set freq in em to no aveil
by all means i will try the funard net id force but it should not need it

I have heard that sometimes the netid / frequency is auto set by the sammy box as though it can auto configure itself. I have never seen this however. or maybe the cc have removed this facility for the sammy boxes?

Either way, just get your net id and freq set to the right values and you'll be away...

this is the first sammy box i have seen that has needed the net id to be set this way all others have auto set can anyone elaborate on why some are like this and others are nort?????

thanks for you sugestions timbo as you might of guessed it appears to be updating now with the corecct valus in place .

cancel that last post its still stuck on lb20 net id and freq are correct ???????????????????????/

ok its most def a tuner problem i just looked inside as i bought it with the talkback allready cut so only opend b4 to quikley short battry and closed up again , but this time i notice the tuner is missing a side pannel and it looks like some soldering has takon place .... would anyone be able to open up there tuner and maby take a pic for me to post up hear so i can see what its suposed to be like please???????


i will also start this thread again under a dif title as it is now about somthing differant ...thanks for those involved up to know ,, wish me look .

I wish you luck!