Woke up this morning, we have had some heavy rain, so it might just be rain water that has got inside the motor, but who knows anyway been up there and checked all connections and resealed. Still no nothing no light on the motor.

Anything else I can try or is it just a matter of waiting for the water to dry out?

Cheers,

Make sure cable from receiver to motor is ok.
Connect cable direct from receiver to lnb bypassing motor to check that cable is ok etc.

Originally Posted by manic01

Make sure cable from receiver to motor is ok.
Connect cable direct from receiver to lnb bypassing motor to check that cable is ok etc.

Yes mate that works

Cable from motor to lnb ok?

what I've done manic is setup a short run to test, left the cable from the lnb to the motor and then run a 10 meter or so into the kitchen and setup the receiver all ok there powering the motor.

The cable that wasn't powering the motor has been joined 3 times to extend the cable, but it's being joined by the use of f plugs and joining connectors, it was all working OK before.

Originally Posted by segel

what I've done manic is setup a short run to test, left the cable from the lnb to the motor and then run a 10 meter or so into the kitchen and setup the receiver all ok there powering the motor.

The cable that wasn't powering the motor has been joined 3 times to extend the cable, but it's being joined by the use of f plugs and joining connectors, it was all working OK before.

Probably water ingress m8,
Replace it before the water reaches your receiver

Sent from my X10i using Tapatalk 2

Sraight cable swap then.

did yu fix it mate? i had exact same prblem it was a faulty power pack for the reciever, replaced power supply and all good again

Originally Posted by madmanc

did yu fix it mate? i had exact same prblem it was a faulty power pack for the reciever, replaced power supply and all good again

Yes m8 just the wires as said all sorted now