Originally Posted by Zorch

Hi again mygoose,

I think what manic1 is referring to is... if your TM 5200D was installed to obtain all of the other FTA channels available on 28.2°East/28.5°East (the positions where nearly all UK Satellite TV providers beam their signals to/from) ...then that would explain the 'No Audio/Video' message you are seeing... there have been massive changes made to frequencies/channels etc. on those satellite positions...

So in all likelihood... a lot of the frequencies/channels originally programmed into/scanned into your TM 5200D may now be defunct/incorrect and will need new frequencies entering and channels re-scanning... or alternatively by deleting all frequencies/channels... then carrying out a full blind search to regain/renew all current frequencies/channels...

But that does not get away from the fact that the Technomate remote control will not operate your TM 5200D... I can think of a few reasons for this...

1/ The TM 5200D is switching on then locking up due to software problems
2/ The feed from the Dish/LNB into the TM 5200D is causing the TM 5200D to lock up
3/ The remote control is faulty/dead
4/ The remote control is not the correct one for the TM 5200D

That is why I asked you if you could change channels using the up and down buttons on the front of your TM 5200D... if this cannot be done then there may be a more serious problem with your TM 5200D

Best Wishes,
Zorch

Zorch you are a star!! You have fixed it.

Will explain later, probably tomorrow.

Many, many thanks

Kindest regards
mygoose

Why not explain now?
Many members have spent time trying to help you here.

Originally Posted by manic01

Why not explain now?
Many members have spent time trying to help you here.

Because I am in hospital intensive care unit with very sick relative now until late.

Sorry - must go

mygoose

Luckily you managed to sort the TM while you were there though.
Bye