| Re: Want to learn to make fun flash!
I am on 3.6 i did all my testing using XNCS as you can send commands etc to card to test. I found just doing a reset card command would show all of the errors in the comms tab.
Just remember guys the logs only give an symptoms of what is wrong. You can go down the wrong route like i did (I rewrote the whole recieve data routine as i thought that where the problem was based on the logs and it made no difference) the logs show what is sent to the card (not what the card recieved)
If we assume that the command response part of the code works OK (as it did in the past). It can only be the card is getting the wrong data and sending an invalid response or no response based on the faulty data. What would make the card recieve the wrong data ?
__________________ You only need two things to fix anything. WD40 and Duct Tape.
If it should move and doesn't Use WD40
If it moves and it shouldn't use the Duct Tape.  |